10/100 Copper to Fiber (SC/MM) Converter - 90-30114 (FT-802)
The 90-30114 is Fast Ethernet Bridge 100Base-FX fiber to 10/100Base-TX shielded twisted pair (STP) converter. It supports selectable for half-duplex and full-duplex operations and supports a variety of fiber options. The converter auto-adapts to the highest level of performance supported by the device connected to the STP port. When the device is a switch or a workstation that supports full duplex, the converter adapts to the full-duplex mode and provides an effective 200Mbps bandwidth. When the connected device is a hub or a workstation that supports only half duplex, the converter adapts to the half-duplex mode and provides the nominal 100Mbps bandwidth. An override switch provides total manual control over the half/full-duplex operation, in fiber-optic interface. The fiber port of converter operates at 1310 nm and uses ST, SC, MT-RJ, VF-45 or WDM connectors. Multi-mode models that support distances up to 2 km and single-mode models that support distances up to 15/35/50 km are available.
- Comply with IEEE802.3, IEEE802.3u 10/100Base-TX, 100Base-FX Standard
One RJ-45 (Auto-MDI/MDI-X) Twisted Pair, EIA568
One Fiber-optic, 1310nm wavelength, connector-type and distance vary with model.
- FT-806A20: Tx-1310nm, Rx-1550nm
- FT-806B20: Tx-1550nm, Rx-1310nm
- Data Transfer Rate:
- Duplex mode support:
Full or half-duplex mode by Auto- Negotiation (TP)
Full or half-duplex mode by DIP-switch (FX)
- LED indicators: PWR, FX LNK/ACT, FX FDX/COL, TP 100, TP LNK/ACT, TP FDX/COL
- DIP-switch: 2 DIP-switches
Rear DIP-switch: FX duplex mode selection
Side DIP-switch: LFP (Link Fault Pass-through) mode selection